- Parquet & Wooden floors
- Sanding machines and electric- tools
- Floor laying and preparing before finish
- For outdoor work
- Oils, waxes and lyes
- Varnishes and epoxy
AquaSeal Pafuki – water-based putty solution
Water-based, solvent-free filler solution for the preparation of wood-filler or putty; good filling property. The wood color shade is achieved by admixing the respective wood flour.
Standard climate 23°C/ 50% rel. humidity, surface can be sanded after approx. 30-45 min.
Approx. 20 m2/l
1l – EUR 19,08
5l – EUR 73,45
* The terms of the contract and the right of withdrawal can be found in the Documents section.
* This product is one of the regulations of the Cabinet of Ministers No. 255, 22nd article exceptions, where the customer cannot exercise the right of withdrawal.
€19,08 – €73,45
AquaSeal® Pafuki is a water-based filler solution for the preparation of wood filler or joint putty. AquaSeal® Pafuki is used for filling joints and cracks within all kinds of wooden surfaces, e.g. hardwood and parquet flooring. Giscode W2+
Application: AquaSeal® Pafuki is mixed into a pasty ready-to-trowel mass. It is recommended to use the fine sanding dust Grid 80 of multiple disc machine (e.g. Trio or Quattro). Unsuitable for this use is the dust got from longitudinal sanding with a belt sander. Joints up to max. 2 mm width are to be richly trowelfilled with the compound. Filler mixtures containing an insufficient quantity of sanding dust will settle down in the joints during the drying process. In case the mixture contains too much sanding dust, adhesion between the filler and the wood may be insufficient after drying so that the filler is torn out of the joints during the next sanding.
The paste prepared with sanding dust should, if possible, be quickly and completely trowel-spread. After drying the last fine sanding is done. This fine sanding must make sure that no residues are left on the floor’s surface.
A floor treated with AquaSeal® Pafuki can be coated with any of our finishes. In all cases it must be made sure that the mass is thoroughly dried through!
The wood filler should be prepared in a container so as to avoid spots in the wood. Always use the sanding dust of the floor to be trowelled.
Joints wider than 2 mm, prior to treating with wood filler, should be filled with wood chips or other suitable materials, such as AquaSeal® PAK-Stop and AquaSeal® Pafudima FlexFill Color. The sanding dust and the surfaces to be repaired must be free of wax and dirt.
Drying: standard climate 23°C/ 50% rel. humidity, surface can be sanded after approx. 30-45 min., large joints and cavities may delay drying. Do not sand before the surface is sufficiently dry.
Consumption. Depending on floor surface and method: 1 trowel coat: approx. 50 ml/m2 resp. approx. 20 m2/l.
Depending on the kind and dimensions of joints, the consumption may increase.
Transport/storage: shelf life of original unopened packing min. 15 months provided that material is transported and stored at a cool and dry place. protected from freezing.
Store in a dry, well-ventilated place at a temperature between 15 ° C and 25 ° C. Protect from heat and direct sunlight. Keep tightly closed.