Mortar Resin MHF 10

Low-viscosity, modified, solvent-free, tintable, odourless epoxy resin hardening system in two components. The material corresponds to “EC1 plus” (very low emission) and can be coloured or highly filled with firedried quartz sand on-site, if required. Indoors and outdoors as primer as well as to produce coloured mortar mixtures with quartz sand.

Consumption
priming: about 1.25 kg / m² per coat; layer of reactive resin: 2.5 g MHF 10 + 25 kg, layer thickness 0.063 – 3.5 mm (1 m layer thickness will suffice 1 m²), 5 kg MHF 10 + 50 kg layer thickness 0.063 – 3.5 mm (1 cm layer thickness 2 m² will suffice;
for pore closure: about 300 g / m² + 9 g thixotropic substance TE 2K (about 1 m² will suffice)

Color
Black, green, red or beige

Packaging
5 kg, A + B comp. – EUR 166.98
30 kg, A + B comp. – EUR 800,78

 

* The terms of the contract and the right of withdrawal can be found in the Documents section.

 

* This product is one of the regulations of the Cabinet of Ministers No. 255, 22nd article exceptions, where the customer cannot exercise the right of withdrawal.

166,98800,78

Clear

Low-viscosity, modified, solvent-free, tintable, odourless epoxy resin hardening system in two components. The material corresponds to “EC1 plus” (very low emission) and can be coloured or highly filled with firedried quartz sand on-site, if required.
Indoors and outdoors as primer as well as to produce coloured mortar mixtures with quartz sand. For coverings which can be walked or driven on in car ports, ramps, manhole covers as well as road building work, etc.

Recommended tools:
slow-rotating electric agitator, suitable mixing vessel, trowel, smoothing trowel, spatula, roller, rubber broom.

Mixing:
Component A and component B are basically delivered in the relevant correct mixing ratios. A scale must be used to determine partial quantities. Thoroughly mix component A via a slow-rotating electric agitator (approx. 300 rpm), then add component B and continue mixing until a homogeneous, lump-free consistency is reached (approx. 2-3 minutes).
To prevent mixing and/or proportioning mistakes, the mixed material must be decanted into a clean, dry container (repotted) and stirred thoroughly again.

Processing:
depending on the application, pour the material onto the pretreated substrate section by section and distribute across the entire surface with a roller or notched trowel. When using a two-layer moisture barrier, apply the first coat without adding quartz sand and allow it to dry. (Consumption approx. 250 g/m2). Wait at least 12 hours or after 48 hours at the most before applying the second coat (consumption approx. 150 g/m2) and then immediately spread dry quartz sand 0.6 – 1.2 completely and thoroughly.
– as moisture barrier and primer roll or smooth unfilled.
– as trowel applied reactive resin mortar MV – 1:10 with QS 0.063 – 3.5 mm

 

Storage

Store in a dry, well-ventilated place at a temperature between 15 ° C and 25 ° C. Protect from heat and direct sunlight. Keep tightly closed.

Gallery