Structured coating SB 2
Solvent-free, glossy, studded, structured, pigmented thin coating in two components on epoxy resin base with medium chemical and mechanical capacity.
Approx. 0.5 – 0.7 kg/m²
15 kg, A+B comp. – EUR 416,00
* The terms of the contract and the right of withdrawal can be found in the Documents section.
* This product is one of the regulations of the Cabinet of Ministers No. 255, 22nd article exceptions, where the customer cannot exercise the right of withdrawal.
Solvent-free, glossy, studded, structured, pigmented thin coating in two components on epoxy resin base with medium chemical and mechanical capacity. Due to the thixotropic setting of the material, a nub-like surface structure is achieved by rolling using a structured roller.
low-speed electric agitator, suitable mixing vessel, structured roller, hand or surface rake, notched trowel A3.
component A and component B are basically delivered in the relevant correct mixing ratios. A scale must be used to determine partial quantities. Thoroughly mix component A using a slow-rotating electric agitator (approx. 300 rpm), then add component B and continue mixing until a homogeneous, lump-free consistency is reached (approx. 2-3 minutes).
To prevent mixing and/or proportioning mistakes, the mixed material must be decanted into a clean, dry container (repotted) and stirred thoroughly again.
Depending on the application, pour the material onto the pretreated substrate section by section and distribute across the entire surface with a suitable tool. (Toothing A3) Roll the thin coating in fresh state immediately crosswise by means of a structured roller.
Can be tinted in approx. RAL colour tones RAL 1001, 1015, 7030, 7032, 7035, 7038, 7040, 7042, 7044, 7046 and 9002
Store in a dry, well-ventilated place at a temperature between 15 ° C and 25 ° C. Protect from heat and direct sunlight. Keep tightly closed.