Mortar Resin MHF 10
Low-viscosity, modified, solvent-free, tintable, odourless epoxy resin hardening system in two components. The material corresponds to “EC1 plus” (very low emission) and can be coloured or highly filled with firedried quartz sand on-site, if required.Indoors and outdoors as primer as well as to produce coloured mortar mixtures with quartz sand.
As primer approx. 0.25 kg/m² per application as coarse mortar: approx. 2.5 kg/m2 per cm, MR: 1:10, QS: 0.063 – 3.5 mm.
Black, green, red or beige
5 kg, A + B comp. – EUR 166.98
30 kg, A + B comp. – EUR 800,78
€166,98 – €800,78
Low-viscosity, modified, solvent-free, tintable, odourless epoxy resin hardening system in two components. The material corresponds to “EC1 plus” (very low emission) and can be coloured or highly filled with firedried quartz sand on-site, if required.
Indoors and outdoors as primer as well as to produce coloured mortar mixtures with quartz sand. For coverings which can be walked or driven on in car ports, ramps, manhole covers as well as road building work, etc.
slow-rotating electric agitator, suitable mixing vessel, trowel, smoothing trowel, spatula, roller, rubber broom.
Component A and component B are basically delivered in the relevant correct mixing ratios. A scale must be used to determine partial quantities. Thoroughly mix component A via a slow-rotating electric agitator (approx. 300 rpm), then add component B and continue mixing until a homogeneous, lump-free consistency is reached (approx. 2-3 minutes).
To prevent mixing and/or proportioning mistakes, the mixed material must be decanted into a clean, dry container (repotted) and stirred thoroughly again.
depending on the application, pour the material onto the pretreated substrate section by section and distribute across the entire surface with a roller or notched trowel. When using a two-layer moisture barrier, apply the first coat without adding quartz sand and allow it to dry. (Consumption approx. 250 g/m2). Wait at least 12 hours or after 48 hours at the most before applying the second coat (consumption approx. 150 g/m2) and then immediately spread dry quartz sand 0.6 – 1.2 completely and thoroughly.
– as moisture barrier and primer roll or smooth unfilled.
– as trowel applied reactive resin mortar MV – 1:10 with QS 0.063 – 3.5 mm